How are research peptides made?

The short answer: most research peptides are made by solid-phase synthesis. The chain is built one amino acid at a time on a solid resin bead, then cut free, purified by HPLC and freeze-dried.

The method shapes what ends up in the vial: which impurities are possible, what the counter-ion is, and why purity has to be measured rather than assumed. Our how we test page covers the testing side.

General information for in vitro laboratory research. For research use only. Not for human or animal consumption.

Method

Building the chain

01

Anchored to a resin

Synthesis starts at the C-terminal end, anchored to an insoluble polymer bead. Bachem describes its resins as beaded polystyrene cross-linked with 1% divinylbenzene.

02

One cycle per amino acid

Each amino acid is added in a four-step cycle: remove the temporary protecting group, wash, couple the next protected amino acid, then wash again.

03

Why a solid support

Because the chain stays on the bead, excess reagents and soluble by-products are removed by simple filtration.

Chemistry

Protecting groups and coupling

01

Temporary protection

The reactive amino group carries a temporary group, usually Fmoc. Piperidine removes it at the start of each cycle.

02

Permanent protection

Reactive side chains carry their own protecting groups for the whole synthesis, such as tBu for serine, threonine and tyrosine.

03

Coupling reagents

Coupling reagents activate the incoming amino acid so the bond forms. DIPEA and NMM are the bases most often used in Fmoc work.

04

Length limits

Chemical synthesis suits shorter chains. Bachem reduces resin loads above 30 to 40 residues, and describes chemical synthesis as simpler for peptides up to about 60 amino acids.

Finishing

From resin to powder

01

Cleavage

Trifluoroacetic acid releases the finished peptide from the resin and removes the side-chain protecting groups in the same step.

02

Purification

The crude material is purified by reverse-phase HPLC, the principal technique for separating the target peptide from related by-products.

03

The salt that remains

Trifluoroacetic acid from cleavage and purification stays behind as a counter-ion. Our salt form guide explains what that means.

04

Freeze-drying

The purified peptide is lyophilized to a dry solid. What is a lyophilized peptide covers the process.

Sources

Where this comes from

General information from a peptide manufacturer’s technical pages: Bachem, Solid Phase Peptide Synthesis (SPPS) explained, Bachem, Peptide Synthesis and Bachem, Peptide Manufacturing. Methods and specifications vary between manufacturers.

FDA statement

These statements have not been evaluated by the U.S. Food and Drug Administration. Neither the statements on this website nor the products of this company are intended to diagnose, treat, cure or prevent any disease.