Why peptides degrade

The short answer: three chemical routes account for most of it. Oxidation of sulfur-containing and aromatic residues, deamidation of asparagine and glutamine, and hydrolysis driven by moisture.

Which route matters depends on the sequence, so stability is specific to each peptide. Our shelf life guide covers how long a vial keeps, and the storage guide covers the handling steps.

General information for in vitro laboratory research. For research use only. Not for human or animal consumption.

Routes

Three ways a peptide changes

01

Oxidation

GenScript names cysteine, methionine and tryptophan as prone to oxidation and recommends anaerobic storage. Bio-Synthesis lists the same three residues.

02

Deamidation

Bio-Synthesis describes deamidation of glutamine and asparagine, which converts those residues to glutamic acid and aspartic acid. JPT notes asparagine in particular.

03

Hydrolysis

Water can break peptide bonds. JPT states that moisture and humidity accelerate hydrolysis, which fragments the chain.

Residues

Which sequences are most at risk

01

Cys, Met and Trp

The oxidation-prone residues. GenScript advises limiting air contact for peptides containing them.

02

Asn and Gln

The deamidation-prone residues. Bio-Synthesis notes that the rate is sequence-dependent.

03

Asp, Glu, Lys, Arg and His

GenScript describes these as prone to absorbing moisture from the air, which it calls deliquescence, and advises a desiccator and a tightly capped vial.

04

Cysteine pairs

Bio-Synthesis also lists oxidative cyclization, in which two cysteine residues form a disulfide bond.

Conditions

What speeds it up

01

Air

Bio-Synthesis suggests replacing the air in a storage container with anhydrous nitrogen or argon.

02

Moisture

Bachem warns that adsorption of water may decrease stability and reduce the overall peptide content, and advises warming vials in a desiccator before opening.

03

Temperature

Bachem advises storing peptides below −15 °C for maximum stability. JPT lists temperature, humidity and air exposure as the main storage variables.

04

Light

JPT lists light among the factors to keep to a minimum, alongside temperature, humidity and air exposure.

Sources

Where this chemistry comes from

General guidance from peptide manufacturers: GenScript, Peptide Storage and Handling Guidelines, JPT, How Long Do Peptides Last?, Bio-Synthesis, Peptide Storage and Handling and Bachem, Care and Handling of Peptides. Degradation is sequence-dependent, so check the specification for each compound.

FDA statement

These statements have not been evaluated by the U.S. Food and Drug Administration. Neither the statements on this website nor the products of this company are intended to diagnose, treat, cure or prevent any disease.