What does net peptide content mean?

The short answer: net peptide content is the share of the powder’s gross weight that is actually peptide. The rest is counter-ions and residual moisture.

It is a different measurement from HPLC purity, and a vial can be highly pure and still have a peptide content well below 100%. What is a lyophilized peptide covers the powder itself.

General information for in vitro laboratory research. For research use only. Not for human or animal consumption.

The weight

What is in the powder besides peptide

01

Salt from synthesis

Synthetic peptides carry counter-ions such as acetate or trifluoroacetate from synthesis and purification. They add weight but are not peptide. See what the salt form means.

02

Water that stays behind

A small amount of bound water remains after freeze-drying, and more can be taken up from the air afterwards.

03

Why it is a range

Published figures are given as ranges, because content depends on the sequence and on how the material was made and purified.

Versus purity

Two different numbers

01

Purity

An HPLC figure: the main peak’s share of the total peak area. It describes what fraction of the detected material is the target peptide. See peptide purity testing.

02

Content

A weight figure: how much of the gross powder weight is peptide rather than salt or water.

03

Both can be true at once

A sample can be highly pure by HPLC and still have a peptide content below 100%, because the non-peptide weight is salt and water rather than another peptide.

04

Which figure a specification gives

A specification may report one, the other or both. Check which is quoted before comparing two suppliers.

In practice

What it means when you weigh out

01

Gross versus net

Weighing out a given mass of powder is not the same as weighing out that mass of peptide, unless the content figure is known.

02

Moisture adds up

Bachem warns that adsorption of water may decrease stability and reduce the overall peptide content.

03

Keep it dry

Warming a cold vial in a desiccator before opening limits the moisture the powder takes up. Our storage guide covers the handling.

04

Ask for the figure

If your work depends on the exact amount of peptide, ask the supplier which figure their specification reports.

Sources

Where this comes from

General information from a peptide manufacturer’s handling guidance: Bachem, Care and Handling of Peptides. Published content ranges are cited on our lyophilized peptide guide. Content is specific to each compound and lot.

FDA statement

These statements have not been evaluated by the U.S. Food and Drug Administration. Neither the statements on this website nor the products of this company are intended to diagnose, treat, cure or prevent any disease.